How To Use Ball Joint Press
How To Use Ball Joint Press. Works with most otc ball joint kits, cups and adapters faster to use: But it takes more than owning a quality ball joint press to get the job done.
I needed both sets to have a combo of the press and the needed adapters to get the joints out and the new ones in. The two sides of the yoke are not parallel and that needs to be accounted for with the angled adapter. For the upper joint, you will have to locate the upper control arm.
I Needed Both Sets To Have A Combo Of The Press And The Needed Adapters To Get The Joints Out And The New Ones In.
Grab a ball joint press kit and put the press onto the ball joint that is damaged or broken. For the upper joint, you will have to locate the upper control arm. Replacing ball joints is one of those jobs where you absolutely need the proper tool to do it right.
The Full Ball Joint Press Is The Most Efficient Way To Get Stubborn Joints Removed.
Tighten the threaded shaft on the ball joint press with a ratchet and socket. The tusk ball joint tool is a must have when it comes to replacing your ball joints. You should hear when the joint stud pops from the lower control arm.
Most Ball Joints Are Press Fit, Though Some May Bolt On To The Control Arm And Do Not Need A Ball Joint Press.
Made from high quality steel that will withstand the high pressures involved with ball joint service. Thankfully, the automotive gurus at otc tools have your back. Press out the ball joint.
You Will Find This Upper Control Arm Typically At The Top Of The Car’s Front Suspension System.
But it takes more than owning a quality ball joint press to get the job done. Works pretty well and i was able to separate the most of the ball joints without damaging the rubber boot (except bmw 740, the ball joint was so big that the tool did not fit. I show you in depth how to press out a bad ball joint and press in a new.
As With Any Suspension Work, Take Great Care To Ensure The Vehicle Is Safely Lifted Off The Ground, Use Jack Stands And Never Work Under A Raised Vehicle With Just A Jack Supporting The Weight.
Bmw sells their special tool for $160) you can also use 2 ton jaw puller if you have enough space. *ball joint tool for most atv/utvs. If there is a snap ring on the ball joint, you will need to remove it before pressing out the ball joint.
Post a Comment for "How To Use Ball Joint Press"